Do you understand the maintenance knowledge of customized Vertical pellet mill? Let’s take a look at it with the editor below!
1. Check the parts regularly, once a month, check whether the movable parts of the worm wheel, worm, lubrication block, bolts, bearings, etc., rotate flexibly and wear conditions. If defects are found, they should be repaired in time, and should not be used reluctantly.
2. The machine should be used in a dry and clean room, and should not be used in places where the atmosphere contains acids and other gases that are corrosive to the body.
3. After the machine is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the bucket, and then install it, ready for the next use.

4. When the roller moves back and forth during work, please adjust the M10 screw on the front bearing to the proper position. If the gear shaft moves, please adjust the M10 screw on the back of the bearing frame to the proper position, adjust the gap so that the bearing does not make a noise, turn the pulley by hand, and the tightness is appropriate. Too tight or too loose can cause damage to the machine. .
5. If the machine is out of service for a long time, wipe the whole body of the machine to clean it, and coat the smooth surface of the machine with anti-rust oil and cover it with a cloth canopy.
In summary, the editor tells: About the maintenance knowledge introduction of customized vertical pellet mill, I hope you can learn more through the introduction of the above editor.